2000 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE

Principles of Operation

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Upon installation of a new rear electronic module (REM), the module must be reconfigured. Refer to MODULE CONFIGURATION .

The Windstar's electronic functions are divided into zones. The front electronic module (FEM) controls the front portion of the vehicle and the rear electronic module (REM) controls the rear portion of the vehicle. These systems rely heavily on the standard corporate protocol (SCP) communication network in order to transmit and receive signals.

The REM controls the following systems:

  • switched system power (relay 3 and 4)
  • rear window defrost relay
  • auxiliary climate control
  • electronic day/night rear view mirror
  • overhead interior lighting
  • sliding door and liftgate power locks
  • fuel sender signal transmission
  • rear park lamps
  • brake lamps (including high-mount stoplamp)
  • backup lamps
  • rear turn signals
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.