Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clearing DTCS
Connect scan tool to Data Link Connector (DLC), located under instrument panel. Turn ignition switch to RUN position. Follow scan tool manufacturer"s instructions for the scan tool being used. All continuous Diagnostic Trouble Codes (DTCs) will be displayed on scan tool screen. Clear all DTCs. Scan tool will retrieve DTCs again after clearing and if any remain they will be displayed. Hard DTCs will be redisplayed after clearing because they cannot be from RCM memory.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.