Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE
Speed Control Cable: Removal
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the accelerator cable snow shield.
- Disconnect the speed control cable from the throttle lever and accelerator cable bracket.
- Press the locking tab and rotate the speed control cable cap to remove.
- Disconnect the speed control cable from the speed control actuator pulley.
- Gently push the retaining spring.
- Disconnect the speed control cable slug from the speed control actuator pulley.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.