Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE
Toe-In Adjustment: Front
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Mercury Marauder, 2004 Mercury Grand Marquis, 2004 Ford Crown Victoria, 2003 Mercury Marauder, and 2003 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
- Start the engine and center the steering wheel. Turn the engine off, and hold the steering wheel in the "straight forward" position by attaching a rigid link from the steering wheel to the brake pedal. Remove the clamps from the bellows boot. See Fig 1 .
- Clean and lubricate the nuts and the tie-rod end threads. Loosen the nuts. Do not allow the bellows boot to twist when the tie-rod is rotated. Rotate the tie-rods to obtain the correct toe setting. See WHEEL ALIGNMENT SPECIFICATIONSΒ .
- Start the engine and recenter the steering wheel. Recheck the toe settings and adjust if necessary. Tighten the nuts to specification. See TORQUE SPECIFICATIONSΒ . Install the clamps.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
