2000 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE

Caster Adjustment

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Mercury Marauder, 2004 Mercury Grand Marquis, 2004 Ford Crown Victoria, 2003 Mercury Marauder, and 2003 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Caster adjustment can effect camber and toe settings. The left caster bushing may have a centering washer that needs to be removed and discarded prior to adjustment.
  1. Loosen the nut and move the arm inward to decrease the caster and outward to increase the caster. See Fig 1 . See WHEEL ALIGNMENT SPECIFICATIONSΒ  .
  2. While holding the arm, tighten the nut to specification. See TORQUE SPECIFICATIONSΒ  . Recheck the camber, caster and toe, and adjust as needed.
Fig 1: Adjusting Caster
G00281172Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.