Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE
Inspection & Verification
WARNING: This page is about a different car, the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, and 2001 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- Verify customer complaint by operating system in question. Inspect vehicle for any obvious electrical component wiring or harness connector damage. Inspect connectors for loose, damaged or corroded terminals. Check central junction box fuse No. 3 (20-amp) and fuses related to system in question.
- Inspect 16-pin Data Link Connector (DLC) harness connector and pins for damage. DLC is located below driver's side of instrument panel, to right of steering column. See Fig 1. If harness connector and pins are okay, go to next step. If harness connector or pins are damaged, repair as necessary and proceed to next step.
- If problem is still present after performing inspection, connect New Generation Star (NGS) tester to DLC. Select vehicle to be tested from NGS tester menu. If NGS tester does not communicate with vehicle, ensure program card is properly installed. Check NGS tester cable connections and ensure ignition switch is in RUN position. If NGS tester still does not communicate with vehicle, diagnose communication network. See TEST M: NO MODULE/NETWORK COMMUNICATION - NO POWER TO NGS TESTERΒ under SYSTEM TESTS. If NGS tester communicates with vehicle, perform data link diagnostic test. See DATA LINK DIAGNOSTIC TESTΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
