2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Contact Assembly (CLOCKSPRING): Installation

  1. Ensure front wheels are in straight-ahead position. Install clockspring. If installing original clockspring, remove tape. If installing NEW clockspring, remove locking insert.
  2. Install upper and lower steering column shrouds. Connect positive battery cable. Connect negative battery cable. Check AIR BAG light for system faults.
Fig 1: Exploded View Of Steering Column (Floor Shift)
G00026123Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.