2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Disabling System

  1. Disconnect negative battery cable. Disconnect positive battery cable. Wait one minute for back-up power supply to deplete.
  2. Remove bolts retaining driver-side air bag to steering wheel. Disconnect driver-side air bag module electrical connector. Attach air bag simulator to air bag electrical connector to simulate air bag. If testing or vehicle operation is required, connect positive battery cable, then connect negative battery cable.
  3. To disable passenger-side air bag, open glove box door to fullest extent by pushing in on tabs and releasing door. Remove retaining bolts. Pull air bag out of instrument panel and disconnect air bag electrical connectors. Attach air bag simulator to wire harness. If testing or vehicle operation is required, connect positive battery cable, then connect negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.