Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Section 522 (Seat System)
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnosis And Testing
- Seats
- Notes
- Special Tool(s)
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The Power Seat Is Inoperative
- Pinpoint Test B: The Power Seat Moves But Is Noisy
- Pinpoint Test C: The Power Seat Moves But Is Loose
- Pinpoint Test D: The Power Seat Does Not Make Full Travel
- Pinpoint Test E: The Power Seat Does Not Move Horizontally/Vertically
- Pinpoint Test F: The Heated Seat Is Inoperative
- Pinpoint Test G: Seat Does Not Heat But The Heated Seat Indicator Illuminates When Pressed
- Seats
- Removal And Installation
- Disassembly And Assembly
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.