2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Compass Zone Adjustment

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Compass Calibration Zone Map
GF0001426Courtesy of FORD MOTOR CO.
  1. Refer to the compass calibration zone map to select the correct compass zone setting for the geographic location of the vehicle.
  2. Press and hold the SELECT button (approximately 3 seconds) until VAR appears on the display. Release the SELECT button.
  3. NOTE: The compass exits the VAR mode if the SELECT button has not been pressed after a period of approximately 5 seconds.
  4. Momentarily press and release the SELECT button to increase the zone increment by 1. Set the zone display number to match the vehicle geographical location on the compass calibration zone map.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.