Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Idle Speed & Mixture
NOTE:
Idle mixture is not adjustable. If idle mixture is incorrect, see appropriate SELF-DIAGNOSTICS - EEC-V article.
IDLE RPM SPECIFICATION (1)
| Application | RPM | ||||||
|---|---|---|---|---|---|---|---|
| Crown Victoria, Grand Marquis & Town Car (2) | 790-815 | ||||||
| Contour & Mystique | |||||||
| 2.0L DOHC | 790-900 | ||||||
| 2.5L | |||||||
| A/T | 700-760 | ||||||
| M/T | 760-800 | ||||||
| Cougar | |||||||
| 2.0L | 790-900 | ||||||
| 2.5L | 700-760 | ||||||
| Continental | 695-760 | ||||||
| Escort | |||||||
| 2.0L SOHC | |||||||
| A/T | 730-790 | ||||||
| M/T | 750-820 | ||||||
| 2.0L DOHC | 750-820 | ||||||
| Focus | |||||||
| 2.0L SOHC | |||||||
| A/T | 730-790 | ||||||
| M/T | 700-800 | ||||||
| 2.0L DOHC | |||||||
| A/T | 730-790 | ||||||
| M/T | 700-750 | ||||||
| LS | |||||||
| 3.0L | 737 | ||||||
| 3.9L | 750-770 | ||||||
| Mustang | |||||||
| 3.8L | |||||||
| A/T | 700-730 | ||||||
| M/T | 700-780 | ||||||
| 4.6L | |||||||
| SOHC | 660-700 | ||||||
| DOHC | 630-750 | ||||||
| Sable & Taurus | |||||||
| 3.0L OHV | 760-900 | ||||||
| 3.0L OHV Flex Fuel | 840-900 | ||||||
| 3.0L DOHC | 700-730 | ||||||
|
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
