2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Oil Pump: Inspection

Check oil pump housing and gears for damage or excessive wear. Check gears for burrs, nicks or scoring. Small imperfections can be removed with an oil stone. If housing or gears are excessively worn, replace oil pump assembly. Inspect pressure relief valve spring for breakage or weak spring tension. Ensure pressure relief valve piston moves freely in bore. If pressure relief valve spring is worn or damaged, replace pump assembly.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.