Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Conventional Bleeding
- Remove dust cap from right rear wheel bleeder screw. Connect hose to bleeder screw. Submerge other end of hose in container of clean brake fluid.
- Loosen bleeder screw while an assistant presses brake pedal through its full travel. Close bleeder screw. Release brake pedal. Wait 5 seconds. Repeat procedure until air bubbles are no longer present at submerged end of hose.
- Repeat procedure at left rear, right front and left front wheels. Refill reservoir after each wheel is bled. When complete, adjust fluid level to .16" (4.1 mm) below MAX line.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.