2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Abs Bleeding Using Scan Tool

  1. This procedure is used to bleed Hydraulic Control Unit (HCU). Connect New Generation Star (NGS) Tester (077-00500) to Data Link Connector (DLC). Enter vehicle identification information. Ensure master cylinder reservoir is full and remains full during this procedure. Use DOT 3 brake fluid. Turn ignition on.
  2. Choose DIAGNOSTIC DATA LINK from menu selection. Next, choose ABS MODULE, then FUNCTION TEST. Prepare to bleed right rear bleeder. Depress and hold brake pedal to half of its travel. Select SERVICE BLEED and depress trigger of NGS. Bleed until clear, bubble-free fluid flows. Repeat procedure for left rear, right front and left front bleeders. Follow scan tool instructions until SERVICE BLEED PROCEDURE COMPLETE message is displayed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.