Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Luggage Compartment Relay
- Remove luggage compartment relay from relay box, located behind left side of instrument panel. See REMOVAL & INSTALLATIONΒ . Check relay continuity. Continuity should exist between terminals No. 85 and 86. Continuity should not exist between terminals No. 30 and 87. See Fig 1 . If continuity is as specified, go to next step. If continuity is not as specified, replace relay.
- Using jumper wires, apply battery voltage to relay terminal No. 86 and ground relay terminal No. 85. Continuity should now exist between terminals No. 30 and 87. See Fig 1 . If continuity is not as specified, replace relay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
