Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Windstar LimitedFACTORY OEM SERVICE PROCEDURE
Wiper/Washer Systems DTCS
NOTE:
Front Electronic Module (FEM)
WIPER/WASHER SYSTEMS DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1244 | Rear Wiper Run Relay Circuit Failure | C |
| B1245 | Rear Wiper Run Relay Circuit Short To Power | C |
| B1342 | ECU Defective | Replace FEM, Clear DTCs And Retest. See FRONT ELECTRONICS MODULE (FEM) |
| B1431 | Wiper Brake/Run Relay Circuit Failure | B |
| B1432 | Wiper Brake/Run Relay Circuit Short To Power | B |
| B1436 | Wiper High/Low Relay Coil Circuit Short To Power | H |
| B1438 | Wiper Switch Circuit Failure | B |
| B1446 | Front Wiper Park Sense Circuit Failure | E |
| B1448 | Wiper Park Sense Circuit Short To Power | E |
| B1450 | Wiper Wash/Delay Switch Circuit Failure | B |
| B1611 | Rear Wiper Switch Circuit Failure | C |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.