Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Windstar LimitedFACTORY OEM SERVICE PROCEDURE
Left Power Sliding Door Module DTCS
LEFT POWER SLIDING DOOR MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1342 | ECU Defective | Clear and document all DTCs. Perform Left Power Sliding Door Module (LPSDM) self-test If DTC B1342 is retrieved again, replace LPSDM See LEFT POWER SLIDING DOOR MODULE (LPSDM) |
| B2238 | Broken Cable Detected | D |
| B2270 (Repair all other DTCs before proceeding with this test) | Power Sliding Door Exceeded Time Allowed To Cinch Door (Exceeded the time allowed to reach primary latch position after reaching secondary latch position) |
E |
| B2271 (Repair all other DTCs before proceeding with this test) | Power Sliding Door Did Not Reach Full Open Position During Self-Test | F |
| B2362 | Remote Key Fob Open/Close Signal Circuit Short To Ground | X |
| B2363 | Position Sensor System Failure | G |
| B2364 | Fuel Filler Door Open Circuit | H |
| B2365 | "B" Pillar Open/Close Switch Circuit Short To Ground | I |
| B2366 | Power Sliding Door Open/Close Switch Circuit Short To Ground | J |
| B2374 | Power Sliding Door Detent Switch Circuit Short To Ground | K |
| B2483 | Enable Signal Open Circuit (Park) | L |
| B2589 | No Power Sliding Door Detent Switch Detected On Closing & Door Reversed | M |
| B2591 | No Power Sliding Door Detent Switch Detected On Unlatch | N |
| B2592 | Door Not Pulled Into Primary During Power Close & High Duty Cycles | O |
| B2593 (Repair all other DTCs before proceeding with this test) | Door Reversed While Closing Due To An Obstacle | P |
| B2594 | No Movement Detected After An Unlatch During Power Open Operation | Q |
| B2603 | Power Sliding Door Not Fully Closed During Power Close During Self-Test When Pulled To Primary Latch Position | R |
| B2604 | Power Sliding Door On/Off Switch Open Circuit | S |
| B2605 | Disable Signal Open Circuit - Vehicle Speed Over 6 MPH | T |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.