Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Windstar LimitedFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Brake Tube Fittings | 13 (18) |
| HCU Bracket-to-Frame Bolts | 22 (30) |
| HCU-To-Mounting Bracket Bolts | 9 (12) |
| Mounting Bracket Bolts | 30-44 (41-60) |
| Proportioning Valve Retaining Bolt | 9 (12) |
| INCH Lbs. (N.m) | |
| ABCM-to-HCU Screws | 35 (4) |
| ABS Sensor Cable Clip Bolt | 80 (9) |
| Wheel Speed Sensor Bolt | 80 (9) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.