Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Windstar LimitedFACTORY OEM SERVICE PROCEDURE
Test F: Restraint Control Module Does Not Respond To NGS Tester
NOTE:
If repairs to a module communication network circuit is required, see REPAIRING BUS WIRINGΒ
. If module replacement is necessary, see PROGRAMMINGΒ
and REMOVAL & INSTALLATIONΒ
.
- Turn ignition switch to OFF position. Deactivate air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article. Disconnect Restraint Control Module (RCM) 26-pin harness connector. Inspect connector for damage. If connector is okay, go to next step. If connector is not okay, repair as necessary.
- Turn ignition switch to OFF position. Measure resistance between RCM harness connector C231 terminal No. 5 (Light Blue/White wire) and Data Link Connector (DLC) terminal No. 7 (Light Blue/White wire). If resistance is less than 5 ohms, replace RCM. If resistance is 5 ohms or more, repair open in Light Blue/White wire between RCM and DLC.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
