Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Windstar LimitedFACTORY OEM SERVICE PROCEDURE
Connector Identification
CONNECTOR IDENTIFICATION
| Connector | See |
|---|---|
| Anti-Lock Brake Control Module Harness Connector (C111) | Fig 9 |
| Data Link Connector (C216) | Fig 4 |
| Front Electronics Module Harness Connector (C190) | Fig 2 |
| Front Electronics Module Harness Connector (C191) | Fig 8 |
| Front Electronics Module Harness Connector (C192) | Fig 6 |
| Front Electronics Module Harness Connector (C346) | Fig 7 |
| In-Line Harness Connector (C100) | Fig 11 |
| In-Line Harness Connectors (C180 & C292) | Fig 5 |
| In-Line Harness Connector (C432) | Fig 3 |
| Instrument Cluster Harness Connectors (C239 & C241) | Fig 8 |
| Instrument Cluster Harness Connector (C240) | Fig 7 |
| Left Power Sliding Door Module Harness Connector (C355) | Fig 2 |
| Next Generation Speed Control Servo Harness Connector (C116) | Fig 1 |
| Powertrain Control Module Harness Connector (C103) | Fig 12 |
| Rear Electronics Module Harness Connector (C340) | Fig 6 |
| Rear Electronics Module Harness Connector (C341) | Fig 8 |
| Rear Electronics Module Harness Connector (C343) | Fig 7 |
| Rear Electronics Module Harness Connector (C344) | Fig 2 |
| Remote Keyless Entry Module Harness Connector (C200) | Fig 2 |
| Restraint Control Module Harness Connector (C231) | Fig 10 |
| Right Power Sliding Door Module Harness Connector (C352) | Fig 2 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.