Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Windstar LimitedFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Anti-Lock Brake Control Module | See Fig 1 |
| Data Link Connector (DLC) | Located Below Driver's Side Of Instrument Panel, Right Of Steering Column |
| Front Electronics Module (FEM) | See Fig 1 |
| In-Line 14-Pin Harness Connector C432 | Located Rear Right Side Of Cargo Area, Behind Panel |
| In-Line 16-Pin Harness Connector C180 | Located Behind Instrument Panel, Above Front Electronics Module (FEM) |
| In-Line 16-Pin Harness Connector C292 | Located Behind Driver's Side Kick Panel |
| In-Line 42-Pin Harness Connector C100 | Located At Left Rear Side Of Engine Compartment |
| Instrument Cluster | See Fig 1 |
| Next Generation Speed Control (NGSC) Servo | See Fig 1 |
| Parking Aid Module (PAM) | See Fig 1 |
| Rear Electronics Module (REM) | See Fig 1 |
| Remote Keyless Entry (RKE) Module | See Fig 1 |
| Restraint Control Module | See Fig 1 |
| Powertrain Control Module (PCM) | See Fig 1 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
