Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Taurus SVG, 3.0 SFACTORY OEM SERVICE PROCEDURE
Power Windows DTCS
POWER WINDOWS DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1302 | Delayed Accessory Relay Coil Circuit Failure | D & E |
| B1304 | Delayed Accessory Relay Coil Circuit Short To Voltage | E |
| B1314 | Battery Saver Relay Coil Circuit Open | Repair battery saver relay circuit as necessary. See ILLUMINATION/INTERIOR LIGHTS - WIRING DIAGRAMS . |
| B1315 | Battery Saver Relay Coil Circuit Short To Voltage | Repair battery saver relay circuit as necessary. See ILLUMINATION/INTERIOR LIGHTS - WIRING DIAGRAMS . |
| B1342 | ECU Defective | Using NGS tester, retrieve and document all continuous DTCs. Perform Generic Electronic Module (GEM) self-test. If DTC B1342 is retrieved again, replace GEM |
| B1359 | Ignition RUN/ACC Circuit Failure | Repair ignition switch circuit as necessary. See STEERING COLUMN SWITCHES . |
| B1398 | Driver's Door Window One-Touch Relay Circuit Failure | B & C |
| B1400 | Driver's Door Window One-Touch Relay Circuit Short To Voltage | C |
| B1405 | Driver's Door Window Down Circuit Short To Voltage | C |
| B1408 | Driver's Door Window Up Circuit Short To Voltage | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
