Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Taurus SELFACTORY OEM SERVICE PROCEDURE
Ignition Switch
- Turn ignition switch to RUN position. Turn ignition lock cylinder to RUN position by rotating ignition switch lock cylinder approximately 90 degrees from LOCK position.
- Install ignition switch pin onto actuator. It may be necessary to move ignition switch slightly back and forth to align ignition switch mounting holes with lock cylinder housing threaded holes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.