2000 Ford Taurus SELFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES

Component Component Location
A/C Clutch Cycling Pressure Switch Right front of engine compartment, behind right headlight.
A/C High Pressure Switch (3.0L 2V) Front center of engine compartment, left of power steering pump.
A/C High Pressure Switch (3.0L 2V FFV) Front center of engine compartment, left of power steering pump.
A/C High Pressure Switch (3.0L 4V) Front center of engine compartment, left of power steering pump.
Anti-Theft Disarm Switch Left side of rear cargo area.
Anti-Theft Hood Switch At left front corner of engine compartment.
Brake Fluid Level Switch Left rear of engine compartment, to right of master cylinder.
Brake Pedal Position (BPP) Switch Under dash, upper front side of brake pedal.
Brake Pressure Switch Behind left side of dash.
Deactivator Switch Behind lower side of brake pedal.
Dual Pressure Switch (3.0L 2V) Behind A/C Compressor.
Dual Pressure Switch (3.0L 2V FFV) Behind A/C Compressor.
Dual Pressure Switch (3.0L 4V) Behind A/C Compressor. See Figure .
Engine Coolant Level Switch Right center of engine compartment, on coolant reservoir.
Inertia Fuel Shut-Off Switch Right rear of vehicle, in cargo area, behind right wheelwell.
Low Coolant Level Switch On right side of engine compartment.
Oil Pressure Switch (3.0L 2V) On right rear of engine block. See Figure .
Oil Pressure Switch (3.0L 2V FFV) On right rear of engine block.
Oil Pressure Switch (3.0L 4V) On left front side of engine block. See Figure .
Parking Brake Switch Under left side of dash, mounted above brake pedal.
Power Steering Pressure Switch (3.0L 2V) Left rear of engine compartment, behind transmission fill tube.
Power Steering Pressure Switch (3.0L 2V FFV) Left rear of engine compartment, behind transmission fill tube.
Power Steering Pressure Switch (3.0L 4V) Left rear of engine compartment, behind transmission fill tube.
Seat Belt Switch Under left front seat.
Transmission Control Switch On shifting lever, on steering column.
Trunk Lid Anti-Theft Switch Rear of cargo area.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.