2000 Ford Taurus SELFACTORY OEM SERVICE PROCEDURE

Master Window Control Switch

Remove master window control switch from vehicle. Check continuity between specified terminals while operating switch to specified position. See MASTER WINDOW CONTROL SWITCH TESTINGΒ  table. See Figure . Replace master window control switch if continuity between specified terminals is not as specified.

MASTER WINDOW CONTROL SWITCH TESTING

Switch Position Between Terminals No. Continuity
One-Touch Down
Down 4 & 8 (1) Yes
Neutral 4 & 8 (1) No
Lock-Out Circuit
Locked 1 & 4 Yes
Unlocked 1 & 4 No
Driver's Side
Up 4 & 6 (1) Yes
Down 4 & 7 (1) Yes
Neutral 2 & 6 (1) ; 2 &7 (1) Yes
Passenger's Side
Up 4 & 4 (1) Yes
Down 3 & 4 (1) Yes
Neutral 2 (1) & 4 (1) ; 2 (1) & 3 (1) Yes
Left Rear
Up 4 & 5 Yes
Down 4 & 6 Yes
Neutral 2 (1) & 5; 2 (1) & 6 Yes
Right Rear
Up 3 & 4 Yes
Down 2 & 4 Yes
Neutral 2 (1) & 3; 2 (1) & 2 Yes
(1) Location of terminal is found in C504a connector only.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.