Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Intermediate Shaft "U" Joint-To-Steering Gear Pinch Bolt | 25 (33) |
| Lock Cylinder Housing Screw | 17 (22) |
| Steering Column Mounting Nut | 11 (15) |
| Steering Column-To-"U" Joint Pinch Bolt | 18 (25) |
| Steering Wheel Bolt | 23-33 (31-45) |
| INCH Lbs. (N.m) | |
| Air Bag Module Bolt (Driver) | 80 (9) |
| Air Bag Module Bolt (Passenger) | 80 (9) |
| Ignition Switch Mounting Screw | 53 (6) |
| Instrument Panel Reinforcement Screw | 80 (9) |
| Multifunction Switch Screws | 18-26 (2-3) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.