2000 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Key Programming - Using Service Card To Add Extra Keys Or Reprogram If All Keys Are Lost

NOTE: This procedure has been updated to include information from Ford factory TSB 99-26-6.
  1. To add an extra key, insert an unprogrammed encoded PATS key in ignition. Insert Ford Service Function (FSF) card VERSION 5.0 or higher into New Generation Star (NGS) or Worldwide Diagnostic System (WDS) tester. Select SERVICE BAY FUNCTIONS then PATS. Enter SECURITY ACCESS which results in a 10 minute delay.
  2. Select IGNITION KEY CODE PROGRAM SELECT. Turn ignition key to run and repeat with all keys to be programmed. Select CANCEL 1 time to return to menu selections. Disconnect NGS/WDS tester and wait 10 seconds. Cycle all new keys in ignition and verify vehicle starts.
  3. If all encoded ignition keys are lost, start with 2 new keys with mechanical cuts matching lock cylinder. Insert Ford Service Function (FSF) card VERSION 5.0 or higher into New Generation Star (NGS) or Worldwide Diagnostic System (WDS) tester. Follow ERASE IGNITION KEY procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.