2000 Ford Focus ZX3, AutomaticFACTORY OEM SERVICE PROCEDURE

Pinpoint Test A: No Communication With The Navigation System Module

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. A1 CHECK THE RECORDED DTCS FROM THE DRIVER DOOR MODULE 
    • Check the recorded results from the driver door module self-test.
    • Are any DTCs recorded? 
  2. A2 CHECK CIRCUITS 30-GK8 (RD/BK) AND 10-GK8 (GY/BK) FOR VOLTAGE 
    • Key in OFF position.
    • Disconnect: Navigation System Module C4209.
    • Key in ON position.
    • Measure the voltage between the navigation system module C4209-1, circuit 30-GK8 (RD/BK), harness side and ground; and between the navigation system module C4209-2, circuit 10-GK8 (GY/BK), harness side and ground.
      Fig 1: Checking Circuits 30-GK8 (RD/BK) And 10-GK8 (GY/BK) For Voltage
      G03931234Courtesy of FORD MOTOR CO.
    • Are the voltages greater than 10.5 volts? 
    • Yes  : GO to  A3.
    • No  : REPAIR the circuit in question. TEST the system for normal operation.
  3. A3 CHECK CIRCUIT 31-GK8 (BK/RD) FOR AN OPEN 
    • Key in OFF position.
    • Measure the resistance between the navigation system module C4209-13, circuit 31-GK8 (BK/RD), harness side and ground.
      Fig 2: Checking Circuit 31-GK8 (BK/RD) For Open
      G03931235Courtesy of FORD MOTOR CO.
    • Is the resistance less than 5 ohms? 
    • Yes  : REFER to MODULE COMMUNICATIONS NETWORK to continue communication diagnostics.
    • No  : REPAIR the circuit. TEST the system for normal operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.