Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Focus ZX3, AutomaticFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module (PCM)
The PCM controls the Zetec-E engine. To enable it to do this, the PCM requires comprehensive information regarding the current operating state of the engine. The PCM obtains this information by means of numerous sensors.
- The PCM controls:
- the fully electronic (EI) ignition system
- the sequential electronic fuel injection (SEFI)
- the air-conditioning system in conjunction with the cooling system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.