Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Passenger's Power Window Control Switch
Remove power window control switch. See POWER WINDOW CONTROL SWITCH under REMOVAL & INSTALLATION. Check continuity between appropriate terminals at appropriate connector with switch in specified position. See PASSENGER'S POWER WINDOW CONTROL SWITCH TESTING table. See Figure . If continuity does not exist as specified, replace switch and retest system operation.
| Switch Position | Continuity Between Connector-Terminals No. |
|---|---|
| Neutral | C488-3 & C488-7, C488-1 & C488-6 |
| Up | C488-3 & C488-7, C488-1 & C488-2 |
| Down | C488-2 & C488-7, C488-1 & C488-6 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.