NOTE: Once programming mode has been entered and transmitter button is pressed for the first time, all previously stored transmitter codes will be erased. All transmitters to be used with this system must be programmed at the same time (maximum of 4 transmitters). Ensure battery is fully charged and anti-theft is not armed or triggered (if equipped) before proceeding with programming procedures.

Close all doors and fasten safety belts to ensure conflicting chimes do sound while programming remotes.
Insert key into ignition. Turn ignition from OFF to ON at least 4 times in 6 seconds, ending with key in OFF position. The GEM is now in a learning mode.
Press and hold any button on remote transmitter until a chime sounds. The chime indicates a successful programming. After a successful programming, the module enters another learning mode in which additional remotes may be programmed until maximum number of remotes is reached.
To program additional remotes, repeat step 3 after each chime. Test all programmed remotes by locking and unlocking doors using remotes.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Remote Transmitter

Use the Manual With the Right Hardware

When to See a Mechanic