2000 Ford Escort AutomaticFACTORY OEM SERVICE PROCEDURE

Pressure Bleeding

  1. Clean reservoir cap area. Connect pressure bleeder. Remove dust cap from right rear wheel bleeder screw. Attach hose to bleeder screw. Submerge other end of hose in container of clean brake fluid.
  2. Open valve on bleeder tank to pressurize system. Maintain system pressure at less than 50 psi (3.5 kg/cm2 ). With brake pedal released, open bleeder screw until air bubbles no longer emerge from submerged end of hose.
  3. Repeat procedure at left rear, right front and left front wheels. When complete, close pressure bleeder tank valve. Remove adapter and adjust fluid level to .16" (4.1 mm) below MAX line. Tighten bleeder screws to specification. See TORQUE SPECIFICATIONSΒ  .
NOTE: Engine must be running to provide adequate voltage to ABS control module during anti-lock control portion of following service bleed procedure. Ensure brake fluid reservoir level remains constant during bleeding procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.