Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Cutaway E250FACTORY OEM SERVICE PROCEDURE
Module Communications Network DTCS
MODULE COMMUNICATIONS NETWORK DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1342 | ECU Defective | Using NGS tester, clear and document continuous DTCs. Perform ACM self-test. If DTC B1342 is retrieved again, replace ACM. |
| B2401 | Tape Deck Mechanism Fault | Verify No tape is in tape deck. Using NGS tester, clear and document continuous DTCs. Perform ACM self-test. If DTC B2401 is retrieved again, repair or replace ACM as necessary. |
| B2402 | CD/DJ Thermal Shutdown | Repair audio system fault. |
| B2403 | CD/DJ Internal Fault | Repair audio system fault. |
| B2404 | Steering Wheel Switch Circuit Fault | Repair audio system fault. |
| U2003 | CD/DJ Is Not Responding | Repair audio system fault. |
| U2005 | Rear Integrated Control Panel Is Not Responding | Repair audio system fault. |
| U2014 | Subwoofer Unit Is Not Responding | Repair audio system fault. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.