Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Axle Hub Retaining Nut | 214 (290) | |
| Ball Joint Bolts (Replacement Ball Joint) | 43 (58) | |
| Ball Joint-To-Steering Knuckle Pinch Bolt | 62 (84) | |
| Brake Caliper Anchor Bracket Bolt | 89 (120) | |
| Brake Caliper Bolt | 21 (28) | |
| Brake Hose Support Bracket | 37 (50) | |
| Control Arm-to-Subframe Bolt | 85 (115) | |
| Engine Mount Through-Bolts | 89 (120) | |
| Front Engine Mount Bolt | 35 (48) | |
| Left Engine/Transaxle Mount Bolt | 61 (83) | |
| Lower Steering Column Yoke Pinch Bolt | 18 (24) | |
| Rear Engine Mount Bolt | 62 (84) | |
| Right Engine Mount Bolt | 61 (83) | |
| Stabilizer Bar Link Nuts | 37 (50) | |
| Stabilizer Bar Mounting Bolts | 35 (48) | |
| Strut Retaining Nut | 34 (46) | |
| Strut Thrust Bearing Nut | 44 (60) | |
| Strut-To-Knuckle Pinch Bolt | 62 (84) | |
| Subframe Mounting Bolts | 96 (130) | |
| Tie Rod End Nut | 27 (37) | |
| Wheel Lug Nut | 94 (127) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.