Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Disabling System
- Disconnect negative battery cable. Disconnect positive battery cable. Wait one minute. This is the time required for backup power supply in diagnostic monitor to deplete its stored energy.
- Remove screws retaining driver-side air bag to steering wheel. Disconnect driver-side air bag module wire harness connector. Attach Air Bag Simulator (Rotunda 105-R0012) to wire harness to simulate air bag. If testing or vehicle operation is required, connect positive battery cable, then connect negative battery cable.
- To disable passenger-side air bag, reach through glove compartment and disconnect air bag module wire harness connector. Attach Air Bag Simulator (Rotunda 105-R0012) to wire harness to simulate air bag. If testing or vehicle operation is required, connect positive battery cable, then connect negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
