Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brakes DTCS
ANTI-LOCK BRAKES DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Possible Cause | Perform Test |
|---|---|---|
| B1318 | Battery Voltage Low | B1318 |
| B1342 | ABS Control Module Internal Failure | Clear DTCs. Repeat self-test. If DTC B1342 reoccurs, replace HCU. Repeat self-test |
| B1484 | Brake Pedal Input Open Circuit | B1484 |
| B1596 | Repair Continuous Codes | Repair all DTCs retrieved |
| C1095 | Pump Motor/ABS Control Module | C1095 |
| C1145 | Right Front Sensor Circuit | C1145 |
| C1155 | Left Front Sensor Circuit | C1155 |
| C1165 | Right Rear Sensor Circuit | C1165 |
| C1175 | Left Rear Sensor Circuit | C1175 |
| C1222 | Wheel Speed Signal | C1222 |
| C1233, C1234, C1235, C1236 | Circuit, Front Sensor, Rear Sensor, Sensor Teeth, Sensor Air Gap, Module | C1233, C1234, C1235 & C1236 |
| C1266 | ABS Valve Power Relay Circuit Failure | Replace HCU, Repeat The Self-Test |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.