2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Item 3: Speed Control Cable Installation Note

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Incorrect wrapping of the speed control cable core wire around the speed control actuator pulley may result in a high idle condition.
  1. Insert the speed control cable slug into the speed control actuator pulley slot.
    1. Gently push the retaining spring.
    2. Insert the speed control cable slug completely into the speed control actuator pulley slot.
      Fig 1: Inserting Speed Control Cable Slug Completely Into Speed Control Actuator Pulley Slot
      G03245290Courtesy of FORD MOTOR CO.
  2. NOTE: Make sure the rubber seal is correctly seated onto the speed control cable cap.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.