2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Symptom Chart

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART

Condition Possible Sources Action
  • No communication with the speed control actuator.
  • Smart junction box (SJB) fuse 18 (10A).
  • SJB.
  • Circuitry.
  • Speed control actuator.
  • The speed control is inoperative - unable to enter self-test
  • Smart junction box (SJB) fuse 18 (10A).
  • SJB.
  • Circuitry.
  • Speed control actuator.
  • The speed control is inoperative - no DTCs
  • Smart junction box (SJB) fuse 18 (10A).
  • SJB.
  • Clockspring.
  • Circuitry.
  • Speed control actuator.
  • Speed control deactivator switch.
  • Speed control switch.
  • The set speed fluctuates
  • Anti-lock brake system (ABS) module.
  • Throttle lever.
  • Speed control actuator.
  • Speed control cable.
  • The speed control does not disengage when the brakes are applied
  • Circuitry.
  • Speed control actuator.
  • Speed control deactivator switch.
  • Stoplamp switch.
  • The speed control switch is inoperative
  • Clockspring.
  • Circuitry.
  • Speed control actuator.
  • Speed control switch.
  • The speed control indicator lamp is always on
  • Instrument cluster.
  • Speed control actuator.
  • The speed control indicator lamp is inoperative
  • Speed control actuator.
  • Instrument cluster.
  • Circuitry.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.