2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Symptom Chart - Acceleration Control

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART

Condition Possible Sources Action
  • Excessive effort needed to depress accelerator pedal and shaft
  • Worn accelerator lever pivot bushing.
  • INSTALL a new accelerator and brake pedal assembly. Refer to BRAKE PEDAL .
  • Accelerator cable binding.
  • INSTALL a new accelerator cable.
  • Worn or damaged throttle body
  • Accelerator pedal and shaft feels rough or raspy
  • Frayed or binding accelerator cable.
  • INSTALL a new accelerator cable.
  • Worn or damaged throttle body.
  • Accelerator pedal and shaft bind or stick
  • Kinked accelerator cable.
  • INSTALL a new accelerator cable.
  • Foreign object caught in accelerator pedal linkage.
  • CHECK the accelerator pedal linkage.
  • Worn or damaged throttle body.
  • High engine idle speed
  • Kinked accelerator cable.
  • INSTALL a new accelerator cable.
  • Foreign object caught in accelerator pedal linkage.
  • CHECK the accelerator pedal linkage.
  • Incorrect engine idle speed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.