2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Block heater retaining screw 2 - 18
Thermostat housing bolts (1) - - -
Coolant bypass tube bracket bolt 10 - 89
Coolant pump inlet tube bolt 25 18 -
Coolant pump pulley bolts 11 8 -
Idler pulley bolt 47 35 -
Generator/AC compressor bracket brace bolts (M10) 47 35 -
Generator/AC compressor bracket brace bolt (M8) 25 18 -
Coolant pump inlet tube bracket bolts 10 - 89
Coolant pump bolts (1) - - -
Transmission cooler bolts 10 - 89
Radiator alignment pins 10 - 89
Lower radiator support bolts 25 18 -
Fan shroud-to-radiator bolts 11 8 -
Degas bottle bolts 10 - 88
(1) Refer to the appropriate procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.