2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

General Specifications

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS

Item Specification
Cooling System Capacity 
With auxiliary heater 15.1 liters (16.0 quarts)
Without auxiliary heater 14.2 liters (15.0 quarts)
Coolant Type 
Motorcraft Premium Gold Engine Coolant VC-7-A (in California and Oregon, VC-7-B, in Canada, VC-7-C) or equivalent (yellow color) WSS-M97B51-A1
Other Chemicals 
Premium Cooling System Flush VC-1 ESR-M14P7-A
Motorcraft Cooling System Stop Leak Pellets VC-6 WSS-M99B37-B6
Cooling System Pressure Test Specification 
Cooling system 138kPa(20psi)
Radiator Cap Pressure Test Specification 
Cap 97-124 kPa (14-18 psi)
Thermostat Opening Temperatures 
Starts to open 87-91°C (188-195°F)
Fully open 100°C(212°F)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.