2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Heater Core Backflushing

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATION

Item Specification
Motorcraft Premium Cooling System Flush VC-1 ESR-M14P7-A
Motorcraft Premium Gold Engine Coolant VC-7-A (in California and Oregon, VC-7-B, in Canada, VC-7-C) or equivalent (yellow color) WSS-M97B51-A1
  1. Partially drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDINGΒ .
  2. NOTE: Refer to the cooling system manufacturer's operating instructions for particular vehicle hookup.
  3. Using an appropriate cooling system flusher, backflush the heater core. Use Ford Premium Cooling System Flush.
  4. Fill the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDINGΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.