2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Section 48 (HVAC System): Description

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For description and operation not covered in this article, see DESCRIPTION & OPERATION in ESCAPE article in HEATER SYSTEMS.

The A/C-heater system is a blend-air type, consisting of a control panel, compressor and clutch, blower motor, evaporator core, condenser core, accumulator-drier and plenum assembly. System is controlled by a clutch cycling pressure switch and a high-pressure cut-off switch. Function selector switch is a vacuum and electrical switch, which controls compressor and air distribution. Temperature control switch uses a cable to control air temperature door position.

Blower motor is located in plenum assembly, under instrument panel. Plenum assembly contains evaporator core, heater core, floor/defrost door, panel/defrost door and cable operated temperature blend door. See VACUUM DIAGRAMSΒ .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.