Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Component Locations
WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Battery Junction Box | Left Front Corner Of Engine Compartment |
| Compressor Clutch Cycling Pressure Switch | Right Side Of Engine Compartment Near Strut Tower |
| Compressor Clutch Diode | Battery Junction Box |
| Compressor Clutch Relay | Battery Junction Box |
| Cylinder Head Temperature Sensor | Right Front Of Cylinder Head |
| Dual Pressure Switch | Lower Right Front Of Engine Compartment |
| Powertrain Control Module | In Recess On Upper Center Of Firewall |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.