2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Symptom Chart

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Refer to SYSTEM WIRING DIAGRAMS for schematic and connector information.

PROBLEM SYMPTOM CHART

Condition Possible Sources Action
  • No communication with the anti-lock brake system (ABS) module
  • Front battery junction box (FBJB) fuse(s) 14(30A), 22 (40A).
  • Circuitry.
  • ABS module.
  • The yellow ABS warning indicator does not self-check
  • Circuitry.
  • ABS module.
  • Spongy brake pedal with no warning indicator
  • Air in brake hydraulic system.
  • REFER to DISC article.
  • The Advance Trac®/IVD is inoperative
  • Rear battery junction box (RBJB) fuse(s) 22 (20A), 25 (40A).
  • Circuitry.
  • Advance Trac®/IVD switch.
  • ABS module.
  • The Advance Trac®/IVD system is always on/cannot be disabled
  • Circuitry.
  • Advance Trac®/IVD switch.
  • ABS module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.