Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
PCM Programming
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 1999 Mercury Villager, 1999 Mercury Tracer, 1999 Mercury Sable, 1999 Mercury Mystique, and 1999 Mercury Mountaineer. However, it is still accessible from the selected car via links, so may be relevant.
For Powertrain Control Module (PCM) programming procedures, see ALL MODELS (PROGRAMMING PCM).
NOTE:
This procedure will erase all transmitters that are programed. Ensure all transmitters to be used with vehicle are available before beginning this procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.