WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 1999 Mercury Villager, 1999 Mercury Tracer, 1999 Mercury Sable, 1999 Mercury Mystique, and 1999 Mercury Mountaineer. However, it is still accessible from the selected car via links, so may be relevant.

iver's window. Turn ignition switch to RUN or ACC position. Access programming connector. Programming connector is behind left trunk trim panel, attached to relay panel. Using jumper wire, momentarily short the 2 terminals of programming connector together. Both doors should lock then unlock to confirm program mode has been entered.
Press any button on keyless entry remote transmitter. Both doors should lock then unlock to confirm that transmitter has been programmed.
Repeat step 2) to program all other transmitter (maximum of 4 transmitters) to be used with this system before exiting programming. To exit programming, turn ignition switch to LOCK position. To confirm programming mode has been exited, both doors should lock then unlock.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Remote Transmitter

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?