WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2003 Mercury Sable, 2003 Mercury Mountaineer, 2003 Mercury Marauder, 2003 Mercury Grand Marquis, and 2003 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

All OBD-II scan tools support Powertrain Control Module (PCM) reset. The PCM Reset allows the scan tool to command the PCM to clear all emission-related diagnostic information. When resetting the PCM, a DTC P1000 will be stored in the PCM until all the OBD-II system monitors or components have been tested to satisfy a drive cycle, without any other faults occurring. See DRIVE CYCLES in appropriate SELF-DIAGNOSTICS article.

The following events occur when a PCM reset is performed:

Clears the number of Diagnostic Trouble Codes (DTCs).
Clears the DTCs.
Clears the freeze frame data.
Clears diagnostic monitoring test results.
Resets status of the OBD-II system monitors.
Sets DTC P1000.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Powertrain Control Module Reset: Description

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?