2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the battery junction box (BJB) aside.
    1. Release the clips.
    2. Position the BJB aside.
    Fig 1: Identifying Battery Junction Box Clips
    G03995580Courtesy of FORD MOTOR CO.
  2. Disconnect the ABS electrical connector.
  3. Remove the 3 ABS module screws and the ABS module.
    • To install, tighten to 2 Nm (18 lb-in).
  4. NOTE: Use the diagnostic tool to configure the ABS module. For additional information, refer to MODULE CONFIGURATION .
  5. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.