2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Component Testing Procedure

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
IGNITION SWITCH (11572) - COMPONENT TESTING

Circuit to test Connect self-powered test light or ohmmeter to terminals Move key to these positions A good switch will indicate
Battery Power Circuit BATT and BATT
A2 and A2
Off/Lock Closed circuit
Run Closed circuit
Start Closed circuit
Accessory Closed circuit
Start power circuit BATT and ST,
BATT and 2
Off/Lock Open circuit
Run Open circuit
Run power circuit BATT and A2,
BATT and 1
Off/Lock Open circuit
Run Closed circuit
Start Open circuit
Accessory Open circuit
Run/Acc power circuit BATT and A1 Off/Lock Open circuit
Run Closed circuit
Start Open circuit
Accessory Closed circuit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.